2-7
Catalyst 2960-S Switch Hardware Installation Guide
OL-19732-04
Chapter 2 Switch Installation
Planning a Switch Stack
Installing the FlexStack Module
Step 1
Use a flat-blade screwdriver to remove the FlexStack module blank cover on the switch back panel.
Figure 2-1
Removing the Blank Cover
Step 2
Grasp the FlexStack module on the sides, and insert it into the module slot. Push the module in
completely until you feel it snap into place.
Figure 2-2
Inserting the FlexStack Module
Step 3
Secure the screws tightly on each side of the module.
Figure 2-3
Securing the FlexStack Module
Note
Make sure the screws are only finger-tight to avoid overtightening.
206761
206762
RATING
100-240~
12-6A, 50-60Hz
20676
3
RATING
100-240~
12-6A, 50-60Hz