C-1
Catalyst 2360 Switch Hardware Installation Guide
OL-22150-02
A P P E N D I X
C
Configuring the Switch with the CLI-Based
Setup Program
You can use the command-line interface (CLI) setup procedure for a standalone switch. To use Express
Setup, see the
Cisco CGS 2360 Getting Started Guide
. Before connecting the switch to a power source,
Chapter 2, “Switch Installation,”
and
Chapter 3, “Power Supply and Fan
Accessing the CLI Through Express Setup
You can access the CLI on an unconfigured switch. Set the switch in Express Setup mode, and connect
an Ethernet port to an Ethernet port on your PC or workstation. Follow the steps in the getting started
guide to turn on the switch and to use Express Setup.
When the switch is in Express Setup mode, open a Telnet session to the switch by entering the IP address
10.0.0.1
. Enter the
setup
user EXEC command. Enter the information described in the
and the
“Completing the Setup Program” section on page C-7
After you have entered the configuration information for the switch, save it to flash memory by using
the
write memory
privileged EXEC command.
Note
In Express Setup mode, the IP address 10.0.0.1
stays active until you enter the
write memory
command.
You lose the Telnet connection after entering the
write memory
command.
For information about using the CLI, see the switch command reference for this release.
Accessing the CLI Through the Console Port
You can use either console port:
•
•
