Cisco BPX 8650, Руководство по установке и настройке

Страница: 187 / 606

8-7
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Chapter 8 Installation with Cisco Cabinets including 7000 Series Routers
Installing a 7200 or 7500 Router in a BPX 8650 Cabinet or Rack
Installing a 7200 or 7500 Router in a BPX 8650 Cabinet or Rack
To install the 7200 or 7500 Router Label Switch Controller assembly in a Cisco cabinet as part of a BPX
8650 installation, use the following procedure:
Note
A hardware kit is provided with the router and router enclosure that contains support brackets and
other required hardware.
Step 1 Assemble the router into the router enclosure:
a.
Place the router into the router enclosure as shown (see Figure 8-6) with the power connector side
of the router toward the hinged front door of the router enclosure.
b. Install the power cord along the top left side of the router and router enclosure.
c.
Mount the front hinged door to the router enclosure by spreading the sides of the router enclosure
slightly so that the holes in each side of the cover engage the pins at the front of the router enclosure.
Note
To open the router enclosure door, use the tabs on top of the door. If these are not
accessible because another device is installed on top of the router, use a screwdriver in
the access cutouts to gently pry open the door.
d.
Secure the router to the router enclosure by using four screws on each side.
e. You can attach cable management brackets now or later, as desired. The upper end of each bracket
hooks into the square cutouts shown in Figure 8-6 and the bottom of each bracket is secured with
screws.