Connecting a USB Flash Device
To connect a USB flash device to the Cisco ASR 902 Router, insert the memory stick in the USB port labeled
MEM. The Flash memory module can be inserted only one way, and can be inserted or removed regardless
of whether the router is powered up or not.
The figure below shows the USB port connector on the Cisco ASR 902 Router.
Figure 56: Cisco ASR 902 Router Flash Token Memory Stick
Removing a USB Flash Device
To remove and replace a USB flash token memory stick from and into a Cisco ASR 902 Router, follow these
steps:
Pull the memory stick from the USB port.
To replace the Cisco USB Flash memory stick, simply insert the module into the USB port labeled MEM, as shown in
Figure
“
Cisco ASR 902 Router Flash Token Memory Stick
”
. The Flash memory module can be inserted only one way,
and can be inserted or removed regardless of whether the router is powered up or not.
You can insert or remove the memory stick whether the router is powered on or
not.
Note
This completes the USB Flash memory installation procedure.
Connecting Timing Cables
When installing the cables to the RSPs, we recommend that you leave a service loop of extra cable to
enable fan tray removal.
Note
Cisco ASR 902 and ASR 902U Aggregation Services Router Hardware Installation Guide
102
Installing the Cisco ASR 902 Router
Connecting a USB Flash Device
