Terminated cable connector
2
Split gasket
1
Step 7
Hand-tighten, then use the open-end wrench to tighten until the split gasket seals around the cable (6 to 7
foot-pounds of torque). There should be 5-10 pounds of cable pull support.
Figure 35: FD Chassis with Cable Gland Installed
Step 8
Insert the RJ45 connectors into the Management, Console, and Alarm ports until the connectors snap into
place. See the above figure.
In certain configurations, like four SFPs, two Cus, and alarm, it is not possible to route the console
and management ports through the three-wire cable gland.
Note
Connecting the Console Port
To configure the router through the Cisco IOS CLI, you must establish a connection between the router console
port and either a terminal or a PC. The console port that is located on the router interior is labeled
CONSOLE
.
The Cisco ASR 901S Series Aggregation Services Router has a single console port that functions as a
DTE-mode console (terminal) port for connecting a console terminal. Use this port to connect a PC terminal,
enabling you to log directly into the router system software to perform configuration or other commands.
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
60
OL-29732-01
Installing the Router
Connecting the Console Port
