controller e3
To configure an E3 controller and enter E3 configuration mode, use the
controller e3
command in global
configuration mode. To return to the default state, use the
no
form of this command.
controller e3 interface-path-id
no controller e3 interface-path-id
Syntax Description
Physical interface or virtual interface.
Use the
show controllers
command to see a list of all controllers currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (
?
) online
help function.
interface-path-id
Command Default
No default behavior or values
Command Modes
Global configuration
Command History
Modification
Release
This command was introduced.
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For the
interface-path-id
argument, use the following guidelines:
•
If specifying a physical interface, the naming notation is
rack
/
slot
/
module
/
port
. The slash between values
is required as part of the notation. An explanation of each component of the naming notation is as follows:
◦
rack
: Chassis number of the rack.
◦
slot
: Physical slot number of the line card.
◦
module
: Module number. A physical layer interface module (PLIM) is always 0.
◦
port
: Physical port number of the interface.
•
If specifying a virtual interface, the number range varies, depending on interface type.
To view the status of the controllers, use the
show controllers e3
command.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
972
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
controller e3