network connection id
To configure a connection identifier for the Multi Service Transport Protocol (MSTP), use the
network
connection id
command in DWDM configuration mode. To remove a connection identifier, use the no form
of this command.
network connection id id-number
no network connection id id-number
Syntax Description
Connection identifier.
id-number
Command Default
No default behavior or values
Command Modes
DWDM configuration
Command History
Modification
Release
This command was introduced.
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Operations
Task ID
read, write
dwdm
Examples
The following example shows how to configure a connection identifier for the Multi Service Transport Protocol
(MSTP).
RP/0/RSP0/CPU0:router#
config
RP/0/RSP0/CPU0:router(config)#
controller dwdm 0/1/0/1
RP/0/RSP0/CPU0:router(config-dwdm)#
network connection id 1/1/1/1
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
28
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
network connection id