PATH
AIS = 0
RDI
= 1
FEBE = 21
BIP(B3) = 0
LOP = 1
NEWPTR = 0
PSE
= 0
NSE
= 0
Active Defects: None
Active Alarms:
None
Alarm reporting enabled for: SF SLOS SLOF B1-TCA B2-TCA PLOP B3-TCA
ATM framing errors:
HCS (correctable):
0
HCS (uncorrectable): 0
APS
not configured
COAPS = 0
PSBF = 0
State: PSBF_state = False
Rx(K1/K2): 00/00
Tx(K1/K2): 00/00
Rx Synchronization Status S1 = 00
S1S0 = 00, C2 = 13
PATH TRACE BUFFER : STABLE
BER thresholds:
SF = 10e-3
SD = 10e-6
TCA thresholds:
B1 = 10e-6
B2 = 10e-6
B3 = 10e-6
Clock source:
line
Configuring AToM VP Cell Mode Relay Support
To configure Any Transport over MPLS (AToM) Cell Mode Relay, perform the following procedure beginning
in global configuration mode:
SUMMARY STEPS
1.
Router(config)#
interface atm slot/subslot/port.subinterface multipoint
2.
Router(config-if)#
no ip address ip-address mask
3.
Router(config-if)#
atm pvp vpi l2transport
4.
Router(config-if)#
xconnect peer-ip-address vc-id
{
encapsulation mpls
|
pw-class pw-class-name
}
5.
Router(config-if)#
end
DETAILED STEPS
Purpose
Command or Action
Enters interface configuration mode for the indicated port on
the specified ATM SPA
Router(config)#
interface atm
slot/subslot/port.subinterface multipoint
Step 1
Removes the IP address that is assigned to this interface (if one
has been configured).
Router(config-if)#
no ip address ip-address mask
Step 2
Creates a permanent virtual path (PVP) used to multiplex (or
bundle) one or more virtual circuits (VCs).
Router(config-if)#
atm pvp vpi l2transport
Step 3
Routes Layer 2 packets over a specified point-to-point VC by
using ATM over multiprotocol label switching (AToM).
Router(config-if)#
xconnect peer-ip-address vc-id
{
encapsulation mpls
|
pw-class pw-class-name
}
Step 4
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
82
OL-14127-17
Configuring the ATM SPAs
Configuring AToM VP Cell Mode Relay Support