385
Cisco Aironet Dual-band Dipole Antenna (AIR-ANT2524DB-R, AIR-ANT2524DG-R, and AIR-ANT2524DW-R)
This antenna is designed for use with Cisco Aironet access points that support simultaneous operation in the 2.4 GHz band and
the 5 GHz band and that have dual-band antenna ports, labeled in orange text.
Features
The antenna has an articulated base that can be rotated 360 degrees at the connection point and from 0 to 90 degrees at its
joint.
Installing the Antenna
CAUTION
: The AIR-ANT2524Dx-R series of antennas are dual-band antennas, meaning that they operate in both the 2.4 GHz
and 5 GHz frequency bands. The AIR-ANT2524Dx-R series antennas have an orange ID band on them to indicate their
dual-band functionality. Connect these antennas only to dual-band antenna ports, which are identified with orange text on Cisco
Aironet access points. Using these antennas on Cisco Aironet access points that employ single-band antennas might result in
lower performance.
To install the antenna:
1.
Verify that the connector to which you are connecting the antenna is a dual-band antenna port, identified by orange text on
the access point.
2.
Align the antenna connector with the RP-TNC connector on the access point.
3.
Engage the antenna connector threads with the RP-TNC connector on the access point.
4.
Tighten the antenna by hand. Do not use a wrench or any other tool to tighten the antenna.
5.
Adjust the antenna articulating joint to the desired position.
Obtain Documentation and Submit a Service Request
For information on obtaining documentation, using the Cisco Bug Search Tool (BST), submitting a service request, and gathering
additional information, see
What’s New in Cisco Product Documentation
To receive new and revised Cisco technical content directly to your desktop, you can subscribe to the
Product Documentation RSS feed
. The RSS feeds are a free service.THE SPECIFICATIONS AND INFORMATION REGARDING
THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS, INFORMATION, AND
RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF ANY
KIND, EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS.
THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE INCORPORATED HEREIN BY
THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY, CONTACT YOUR
CISCO REPRESENTATIVE FOR A COPY.
The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference, in which case users will be required to correct the interference at their own expense.
The following information is for FCC compliance of Class B devices: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
