Cisco 7902G - Unified IP Phone VoIP, Руководство администратора

Страница: 67 / 208

3-3
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
OL-8151-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Before You Begin
Network and Access Ports
The back of the Cisco Unified IP Phone 7912G has two RJ-45 ports. The network
port is labelled “10/100SW” and the access port is labeled “10/100PC.” The back
of the Cisco Unified IP Phone 7902G and 7905G have one RJ-45 network port.
The two ports on the Cisco Unified IP Phone 7912G each support 10/100 Mbps
half- or full-duplex connections to external devices. The speed and connection
type are set through auto-negotiation. The single port on the
Cisco Unified IP Phone 7902G and 7905G supports 10 Mbps half-duplex
connections to external devices. You can use either Category 3 or 5 cabling for
10-Mbps connections, but you must use Category 5 for 100 Mbps connections.
Table 3-1 Configuration Activities
Activity Explanation Reference
Auto-registration. If you plan to use auto-registration,
verify that it is enabled and properly
configured in
Cisco Unified CallManager before
connecting any Cisco Unified IP Phone
to the network. See the “Adding Phones to the
Cisco Unified CallManager
Database” section on page 2-9
.
Configure and assign
telephony features. You must use
Cisco Unified CallManager
Administration to configure and assign
telephony features to the
Cisco Unified IP Phones. See the “Configuring Telephony
Features Using
Cisco Unified CallManager
Administration” section on
page 5-2
.
Add and associate
users. In Cisco Unified CallManager
Administration, you can add users to
the database and associate them with
specific phones. In this way, users gain
access to web pages that allow them to
configure phone options such as call
forwarding and speed dialing. See the “Adding Users to
Cisco Unified CallManager”
section on page 5-10
.