3-2
Cisco 380 and Cisco 680 Series Hardware Installation Guide
OL-29172-01
Chapter
Remote Power Management
Remote power management allows remote reboot of the appliance. To perform the remote power cycle,
you need to:
•
Connect the appliance interface to a remotely accessible network
•
Configure the interface via AsyncOS using the “remotepower” command
•
When needed, perform the Power Rest directly to the chassis using software that speaks IPMI
(Intelligent Platform Management Interface)
Enable Remote Power Management
To enable remote power management:
Step 1
Connect the “remote power management” RPC interface port of the appliance to a remotely accessible
network.
Step 2
Using SSH, telenet, or the serial port to access the appliance AsyncOS CLI, enter the “remotepower”
command. This command is only available via CLI.
The access to IPMI remote power commands display as currently disabled.
Step 3
From the setup prompt, enter
setup
to configure IPMI for chassis remote power access.
Step 4
Type
y
and enter to enable remote access.
Step 5
Enter the IP address (IPv4 only) for the chassis. For example:
1.1.1.2
Step 6
Enter the netmask. For example:
255.255.255.0
Step 7
Enter the gateway address. For example:
1.1.1.1
Step 8
Enter the username and password that will be used to log in to the chassis. For example, username
“admin” and password.
Note
The username and password entered here are independent of the AsyncOS.
This username and password are sent in clear text and will be visible to anyone who can monitor your
network. You should take precautions to ensure the remote management port is connected directly to a
secure network.
Step 9
Enter the password again to confirm.
The current remote power settings are displayed.
Step 10
At the setup prompt enter (or hit return key) and from the chassis prompt, enter
commit
to save your
changes.
Содержание 380 Series
Страница 11: ...xi Cisco 380 and Cisco 680 Series Hardware Installation Guide OL 29172 01 Conventions ...
Страница 26: ...1 12 Cisco 380 and Cisco 680 Series Hardware Installation Guide OL 29172 01 Chapter ...
Страница 40: ...3 6 Cisco 380 and Cisco 680 Series Hardware Installation Guide OL 29172 01 Chapter ...