2-7
Cisco 380 and Cisco 680 Series Hardware Installation Guide
OL-29172-01
Chapter
Figure 2-2
Inserting the Appliance Into the Slide Rails
Connecting the Interface Cables and Verifying Connectivity
This section describes how to connect the cables to the console and anagement ports.
Warning
Only trained and qualified personnel should install, replace, or service this equipment
.
Statement 49
Caution
Read the safety warnings in the
Regulatory Compliance and Safety Information for Cisco Content
Security Appliances
Safety and Compliance Guide for Cisco IronPort Appliances
and follow
proper safety procedures when performing any tasks in this document.
To connect cables to the ports, perform the following steps:
Step 1
Place the appliance on a flat, stable surface, or in a rack (if you are rack-mounting it).
Step 2
Before connecting a computer or terminal to the ports, determine the baud rate of the computer console port.
The baud rate must match the default baud rate (9600 baud) of the console port of the Cisco 380 and Cisco
680 Series appliance. Set up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop bits,
and Flow Control (FC) set to Hardware.
Step 3
Connect the cables to the ports.
a.
Management port—For more information, see the figures in
PCI NIC Slot Configurations, page 1-4
for illustrations of the management port on the Cisco 380 and Cisco 680 appliance.
1
2
3
4
330534
1
Inner rail on appliance
3
Slide rail assembly on rack post
2
Slide rail locking clip
4
Right-front rack post
Содержание 380 Series
Страница 11: ...xi Cisco 380 and Cisco 680 Series Hardware Installation Guide OL 29172 01 Conventions ...
Страница 26: ...1 12 Cisco 380 and Cisco 680 Series Hardware Installation Guide OL 29172 01 Chapter ...
Страница 40: ...3 6 Cisco 380 and Cisco 680 Series Hardware Installation Guide OL 29172 01 Chapter ...