Cisco 3750 - Catalyst EMI Switch, Справочник по командам

Страница: 345 / 1154

2-315
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
logging event power-inline-status
logging event power-inline-status
Use the logging event power-inline-status interface configuration command to enable the logging of
Power over Ethernet (PoE) events. Use the no form of this command to disable the logging of PoE status
events; however, the no form of this command does not disable PoE error events.
logging event power-inline-status
no logging event power-inline-status
Syntax Description
Defaults Logging of PoE events is enabled.
Command Modes Interface configuration
Command History
Usage Guidelines The power-inline-status keyword is available only on PoE interfaces.
Examples This example shows how to enable logging of PoE events on a port:
Switch(config-if)# interface gigabitethernet1/0/1
Switch(config-if)# logging event power-inline-status
Switch(config-if)#
Related Commands
power-inline-status Enable the logging of PoE messages.
Release Modification
12.1(19)EA1 This command was introduced.
Command Description
power inline Configures the power management mode for the specified PoE port or for all
PoE ports.
show controllers
power inline Displays the values in the registers of the specified PoE controller.