Cisco 3750 - Catalyst EMI Switch, Справочник по командам

Страница: 196 / 1154

2-166
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
dot1x violation-mode
dot1x violation-mode
Use the dot1x violation-mode interface configuration command to configure the violation modes that
occur when a new device connects to a port or when a new device connects to a port after the maximum
number of devices are connected to that port.
dot1x violation-mode { shutdown | restrict | protect }
no dot1x violation-mode
Syntax Description
Defaults By default dot1x violation-mode protect is enabled.
Command Modes
Interface configuration
Command History
Examples This example shows how to configure an IEEE 802.1x-enabled port as error disabled and to shut down
when a new device connects to the port:
Switch(config-if)# dot1x violation-mode shutdown
This example shows how to configure an IEEE 802.1x-enabled port to generate a system error message
and change the port to restricted mode when a new device connects to the port:
Switch(config-if)# dot1x violation-mode restrict
This example shows how to configure an IEEE 802.1x-enabled port to ignore a new connected device
when it is connected to the port:
Switch(config-if)# dot1x violation-mode protect
You can verify your settings by entering the show dot1x [ interface interface-id ] privileged EXEC
command.
shutdown Error disables the port or the virtual port on which a new unexpected MAC
address occurs.
restrict Generates a syslog error when a violation error occurs.
protect Silently discards packets from any new MAC addresses. This is the default
setting.
Release Modification
12.2(46)SE1 This command was introduced.