10
Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards
78-13892-03
March 2002
Internal CompactFlash Memory Card Installation and Removal
Complete the following procedure to remove the chassis cover:
Step 1
Power OFF the router. However, to channel ESD voltages to ground, do not unplug the power cable.
Warning
Before opening the chassis, disconnect the telephone-network cables to avoid contact with
telephone-network voltages. To see translations of the various warnings that appear in this
publication, refer to the Regulatory Compliance and Safety Information document that
accompanied this device.
Step 2
Disconnect all network interface cables from the rear panel.
Step 3
Place the router on a flat surface. Remove the screws located on top of the cover (five screws on a
Cisco 2691 or Cisco 3631 router; six screws on a Cisco 3725 router). Set the screws aside in a safe
place.
Step 4
Rotate the cover up to a 45-degree angle. (See
Figure 10
,
Figure 11
, or
Figure 12
.)
Step 5
Slide the cover to the side (away from the side with the fans) until the tabs are free from the slots. (See
Figure 10
,
Figure 11
, or
Figure 12
.)
To replace the cover, see the
“Reinstalling the Cover on a Cisco Router” section on page 16
.
