Security
Configuring
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
392
19
NOTE
If more than one server has been configured, the device uses the
configured priorities of the available servers to select the
server to be used by the device.
The page enables configuring servers.
Only users who have privilege level 15 on the server can administer the
device. Privilege level 15 is given to a user or group of users on the
server by the following string in the user or group definition:
service = exec {
priv-lvl = 15
}
To configure server parameters:
STEP 1
Click
Security
>
.
STEP 2
Enable
Accounting
if required. See explanation in the
section.
STEP 3
Enter the following default parameters:
•
Key String
—Enter the default
Key String
used for communicating with all
servers in Encrypted or Plaintext mode. The device can be
configured to use this key or to use a key entered for an specific server
(entered in the Add Server page).
If you do not enter a key string in this field, the server key entered in the Add
Server page must match the encryption key used by the
server.
If you enter both a key string here and a key string for an individual
server, the key string configured for the individual server takes
precedence.
•
Timeout for Reply
—Enter the amount of time that passes before the
connection between the device and the server times out. If a
value is not entered in the Add Server page for a specific server,
the value is taken from this field.
•
Source IPv4 Interface
—Select the device IPv4 source interface to be used
in messages sent for communication with the server.
