Cisco 3310 Mobility Services Engine, Руководство по началу работы

Страница: 39 / 60

5-3
Cisco 3310 Mobility Services Engine Getting Started Guide
OL-17304-02
Chapter 5 Initial Configuration
Connecting and Using the CLI Console
Connecting and Using the CLI Console
For initial system configuration, use a terminal emulator program to access the command-line interface
(CLI) console. The serial console cable connects to the mobility services engine back-panel DB-9
console port. Refer to
Figure 1-3 on page 1-3 for the location of the serial console port. For console port
pinouts, refer to the “DB-9 Serial Connector Pin Assignments” section on page 1-4 .
Use these terminal emulator settings for the CLI console session:
• 9600 baud
•
8 data bits
• No flow control
•
1 stop bit
• No parity
Powering On the Mobility Services Engine
When you apply AC power to a mobility services engine, the bootup script initializes the operating
system and its stored configurations. You are prompted to enter a user ID and password and enter key
configuration details.
Follow these steps to power on the mobility services engine.
Step 1
Plug an AC power cord into the back of the power supplies of the mobility services engine ( Figure 1-3
on page 1-3 ), and connect the other end to a grounded 100 to 240 VAC 50/60 Hz electrical outlet.
The end of the power cord that plugs into the mobility services engine conforms with the IEC 320
standard.
Step 2
Press the front-panel power button to turn on the mobility services engine (refer to Figure 1-2 on
page 1-3 ).
Step 3 At the login prompt, enter the mobility services engine operating username and password. The default
username is root and the default password is password.
The username and password are case sensitive.
You are now logged into the mobility services engine operating system.
Continue to the “Configuring the Mobility Services Engine” section.