3-18
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 3 Configuring Ports and Interfaces
Configuring Dynamic Interfaces
Using the CLI to Configure Dynamic Interfaces
Follow these steps to configure dynamic interfaces using the CLI.
Step 1
Enter
show interface summary
to view the current dynamic interfaces.
Step 2
To view the details of a specific dynamic interface, enter
show interface detailed
operator_defined_interface_name
.
Step 3
Enter
config wlan disable
wlan_id
to disable each WLAN that uses the dynamic interface for
distribution system communication.
Step 4
Enter these commands to configure dynamic interfaces:
•
config interface create
operator_defined_interface_name
{
vlan_id
|
x
}
•
config interface address
operator_defined_interface_name
ip_addr ip_netmask
[
gateway
]
•
config interface vlan
operator_defined_interface_name
{
vlan_id
|
0
}
•
config interface port
operator_defined_interface_name
physical_ds_port_number
•
config interface dhcp
operator_defined_interface_name
ip_address_of_primary_dhcp_server
[
ip_address_of_secondary_dhcp_server
]
•
config interface quarantine vlan
interface_name vlan_id
Note
Use this command to configure a quarantine VLAN on any interface.
•
config interface acl
operator_defined_interface_name
access_control_list_name
Note
See
for more information on ACLs.
Step 5
Enter
config wlan enable
wlan_id
to re-enable each WLAN that uses the dynamic interface for
distribution system communication.
Step 6
Enter
save
config
to save your changes.
Step 7
Enter
show interface detailed
operator_defined_interface_name
and
show interface summary
to
verify that your changes have been saved.
Note
If desired, you can enter
config interface delete
operator_defined_interface_name
to delete a
dynamic interface.
