6-47
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Step 16
To add an access point to this access point group, check the check box to the left of the access point name
and click
Add APs
. The access point now appears in the list of access points currently in this access
point group.
Note
To select all of the available access points at once, check the
AP Name
check box. All of the
access points are then selected.
Note
If you ever want to remove an access point from the group, check the check box to the left of the
access point name and click
Remove APs
. To select all of the access points at once, check the
AP Name
check box. All of the access points are then removed from this group.
Note
If you ever want to change the access point group to which an access point belongs, click
Wireless
>
Access Points
>
All APs
>
ap_name
>
Advanced
tab, choose the name of another
access point group from the
AP Group Name
drop-down box, and click
Apply
.
Step 17
Click
Save Configuration
to save your changes.
Using the CLI to Create Access Point Groups
Using the controller CLI, follow these steps to create access point groups.
Step 1
To create an access point group, enter this command:
config wlan apgroup add
group_name
Note
To delete an access point group, enter this command:
config wlan apgroup delete
group_name
.
A warning message appears if you try to delete an access point group that is used by at least one
access point. If you proceed, any access points assigned to this access point group are moved to
the default-group access point group.
Step 2
To add a description to an access point group, enter this command:
config wlan apgroup description
group_name description
Step 3
To assign a WLAN to an access point group, enter this command:
config wlan apgroup interface-mapping
add
group_name wlan_id interface_name
Note
To remove a WLAN from an access point group, enter this command:
config wlan apgroup
interface-mapping delete
group_name wlan_id
.
Step 4
To enable or disable NAC out-of-band support for this access point group, enter this command:
config wlan apgroup nac
{
enable
|
disable
}
group_name wlan_id
