Cisco 1552 Series, Руководство по установке

Страница: 89 / 139

3-75
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Chapter 3 Installing the 1552 Series Access Points in Hazardous Locations
Powering the Access Point
Figure 3-22 Inserting RJ-45 Connector into the Ethernet Port Opening in Case
Step 8
Slide the liquid-tight adapter towards the access point, and screw the threaded end of the adapter into the
access point, and hand-tighten.
Step 9 Use an adjustable wrench, a 22-mm socket, or a Sealcon S-2200-WR wrench to tighten the threaded end
of the adapter to 6 to 7 ft lbs (8.1 to 9.5 Nm).
Step 10
Use an adjustable wrench and tighten the round end of the adapter to 2.7 to 3.2 ft lbs (3.66 to 4.34 Nm).
Step 11 Ensure that the antennas are connected to the access point before you apply power to the access point.
Step 12
Route your Ethernet cable, and cut off any excess cable.
Step 13 Install an RJ-45 connector on the unterminated cable end, and insert it into the power injector. For typical
installation components, see
Chapter 2, “Components in a Typical Access Point Installation” .
Step 14
Turn on power to the power injector.
Connecting a 24 VDC Power Cable to the Access Point
Caution The DC branch circuit powering the access point must be limited to no more than 10A from the
over-protection device supplied by the user. This branch power supplemental protection and all
connecting conduit, must meet all local and national electrical codes.
To route and connect the 24 VDC power cable to the 1552SA/1552SD or 1552WU access point model,
follow these steps:
1
Liquid-tight adapter (PG 13.5 thread size)
3
RJ-45 connector
2 Ethernet port opening in access point case 4 Shielded outdoor-rated Ethernet (CAT5e or
better) cable