VCC-5CL5M/R
Rev.905-0073-01
©2017 CIS Corporation. All rights reserved.
2
1.
Handling Precautions
1.1.
Camera Handling Precautions
・
Do not apply excessive force or static electricity that could damage the camera.
・
Do not use or store the camera in the extremely dusty or humid places.
・
Do not shoot direct images that are extremely bright (e.g., strong light source, sun, etc.). When strong light such as spot
light was shed, blooming or smear may occur. Put the lens cap on when camera is not in use.
・
Confirm the mutual ground potential carefully before connecting the camera to monitors or computers. Any AC leaks or
coupling noises from the connected devices may cause damages or destroy the camera.
・
When mounting the camera to a seating base or others, please be careful not to make the lens contact the base. And
refer to the camera drawings and note the restrictions on screws to be used.
・
When attaching a lens to the camera, remove the C mount lens cap right before installation to avoid dust on the sensor.
・
Follow the Industrial Wastes disposal methods and rules in accordance with the laws and regulations of respective
countries and municipalities.
・
5 seconds shall be waited after power is turned ON to operate the camera properly.
1.2.
Restrictions on Applications
・
The camera must not be used for any nuclear equipments or aerospace equipments with which mechanical failure or
malfunction could result in serious bodily injury or loss of human life. Our warranty does not apply to damages or defects
caused by irregular and/or abnormal use of the product.
・
The camera must not be used under conditions or environments other than specified in this manual.
1.3.
Disclaimers (exception clause)
CIS shall be exempted from taking responsibility and held harmless for damages or losses incurred by the following cases.
・
In case damages or losses are caused by earthquake, lightning strike, fire, or other acts of God.
・
In case damages or losses are caused by deliberate or accidental misuse by the user, or failure to observe the information
contained in the instructions in this Product Specification and Operational Manual.
・
In case damages or losses are caused by repair or modification conducted by the customer or any unauthorized party.
・
CIS compensates the noticeable CMOS pixel defects found at the shipping inspection prior to our shipment. On very rare
occasions, however, CMOS pixel defects might be noted with time of usage of the products. Cause of the CMOS pixel
defect is the characteristic phenomenon of CMOS sensor itself and CIS is exempted from taking any responsibilities for
them.
1.4.
Precautions on Exporting
・
When exporting our products, fully follow
administrative
regulations, such as “Export Trade Control Order”, “Foreign
Exchange Control Order”, and “Catch-All Controls”, and carefully research on your end customer and its applications to
classify and determine if it is appropriate to export.
※
Refer to the METI web (Ministry of Economy, Trade and Industry) for the details.
http://www.meti.go.jp/policy/anpo/index.html
