Cirris Signature 1000HN, Руководство пользователя

Страница: 27 / 86

1000HN User’s Guide / page 27
How to test your first
cable
Now that you have installed any expansion boxes you will be using, have installed
your connector adapters, have checked the option settings, and have programmed the
analyzer by learning a Sample Cable (see page 23), or by retrieving a cable from the
analyzer’s memory (see page 31), you are ready to test your first cable.
To test your first cable, follow these steps:
1. Disconnect and remove the Sample Cable from the analyzer.
2. Connect the cable you want to test to the analyzer.
• Once you have connected the cable, the analyzer will automatically
begin the test. (
Note
: If you have set the
Auto Hipot
option to
OFF
, the
analyzer will stop after the continuity and conductance tests, prompt
Ready To Hipot
, and wait for you to press
Function
to begin the hipot
test.)
•
WARNING!!
Do not connect a powered (“live”) cable to the
analyzer! This will seriously damage your analyzer, and will
immediately void any stated or implied warranty.
Check the display,
interpret the sounds
As the analyzer does cable tests, it will display results on its LCD display, and will
emit sounds. Here’s how to interpret what you see and hear:
If a cable is good:
The display prompts the same alphanumeric signature as the Sample Cable. The
display will show
Good R<X.X
Ω
. The analyzer will emit a steady clicking sound.
• To continue testing, disconnect the good cable, then replace it with
another cable you want to test.
SIG:XXXXXX-XXXX
GOOD R<XXX
Ω
Section 5: Test
Your First Cable