Circutor Compact DC 2, Инструкция по эксплуатации

Страница: 10 / 78

10
COMPACT DC
Instruction Manual
3�2�- INSTALLATION
The
COMPACT DC
is designed to be assembled on a DIN rail, with standard fixing points to attach it to
the rail.
Terminals, opening roofs or removing elements can expose parts that are hazardous to
the touch while the device is powered. Do not use the device until it is fully installed.
To connect the device, always start by connecting the neutral before the phases and
to disconnect it, firstly remove the phases and then the neutral. Otherwise, the device
could be damaged if there is voltage present during this process.
Warning:
all the terminals must be fixed with side fixing screws to avoid false contacts.
3�3�- DEVICE TERMINALS
3�3�1�- COMPACT DC SBT, DC-S SBT, DC 3G and DC-S 3G MODELS
Table 3:List of COMPACT DC SBT, DC-S SBT, DC 3G and DC-S 3G terminals�
COMPACT DC SBT, DC-S SBT, DC 3G and DC-S 3G terminals
1: L
, Auxiliary power supply
9: RR
, S2 current output L1
2: N , Auxiliary power supply 10: S , S1 current input L2
3: L1
, PLC connection
11: Vs,
Voltage input L2
4: L2, PLC connection 12: SS , S2 current output L2
5: L3
, PLC connection
13: T
, S1 current input L3
6: N , PLC connection 14: Vt , Voltage input L3
7: R
, S1 current input L1
15: TT
, S2 current output L3
8: Vr, Voltage input L1 16: N, Voltage input neutral
L
N
L1
L2
L3
N
R
Vr
RR
S
Vs
SS
T
Vt
TT
N
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Figure 1:COMPACT DC SBT, DC-S SBT, DC 3G and DC-S 3G terminals�