CipherLab 9400CE, Справочное руководство

Страница: 98 / 111

88
9400CE Mobile Computer Reference Manual
Read Redundancy None
Level 0 = None No redundancy means one successful decoding will make the reading valid
and induce the "READER Event".
Level 1 = One time
Level 2 = Two times
Level 3 = Three times The higher the reading security is (that is, the more redundancy the user
selects), the slower the reading speed gets.
If "Three Times" is selected, it will take a total of four consecutive
successful decodings of the same barcode to make the reading valid.
Time-out 3 sec.
1~255 (second) It applies to the following scan modes only:
Aiming mode
Laser mode
Auto Off mode
Auto Power Off mode
SYMBOLOGY SETTINGS TABLE
CCD/LASER DESCRIPTION DEFAULT
Codabar Enable
Select Start/Stop
Characters If "Transmit Start/Stop Characters" is desired, select one
set:
abcd / abcd
abcd / tn*e
ABCD / ABCD
ABCD / TN*E
abcd / abcd
Transmit Start/Stop
Characters Decide whether to include the start/stop characters in the
data being transmitted. No
Code 128 / EAN-128 Enable
Transmit Code ID (for
EAN-128) Decide whether to include Code ID (“]C1”) will be
included in the data being transmitted. No
Industrial 25 (= Discrete 25) Enable
Start/Stop Selection This decides the readability of all 2 of 5 symbology variants.
For example, flight tickets actually use an Industrial 2 of 5
barcode but with Interleaved 2 of 5 start/stop pattern. In
order to read this barcode, the start/stop pattern selection
parameter of Industrial 2 of 5 should set to "Interleaved
25". Industrial 25
Verify Checksum Decide whether to verify the checksum. If the checksum is
incorrect, the barcode will not be accepted. No