Ciara Astro PB60S, Руководство пользователя

Страница: 16 / 68

CIARA Astro PB60S
- 16 -
1.4 Troubleshooting your system after first install
1.4.1 Helpful hints
If you encounter some minor problems with the micro PC, monitor, or software, see the following list of general suggestions before
taking further action :
•
Check that the micro PC and monitor are plugged into a working electrical outlet.
•
Check to see that the micro PC is turned on.
•
Check to see that the monitor is turned on and the monitor light is on.
•
Turn up the brightness and contrast controls of the monitor if the monitor is dim.
•
Press and hold any key. If the system beeps, then the keyboard should be operating correctly.
•
Check all cable connections for loose connections or incorrect connections.
•
Wake the micro PC by pressing any key on the keyboard or pressing the power button. If the system remains in suspend
mode, shut down the micro PC by pressing and holding the power button for at least four seconds then press the power
button again to restart the micro PC. If the system will not shut down, unplug the power cord, wait a few seconds, and then
plug it in again. The micro PC will restart if automatic start on power loss is set in the BIOS. If it does not restart, press the
power button to start the micro PC.
•
Be sure that all the needed device drivers have been installed. For example, if you are using a printer, you need a driver for
that model of printer.
•
If you have installed an operating system other than the factory-installed operating system, check to be sure that it is
supported on the system.
•
Your system can support two independent monitors using any of the two available DisplayPort connectors