Chrysler 300 SRT 2019, Руководство пользователя

Страница: 33 / 592

Power Lumbar — If Equipped
Vehicles equipped with power driver or passen-
ger seats may also be equipped with power
lumbar. The power lumbar switch is located on
the outboard side of the power seat. Push the
switch forward or rearward to increase or de-
crease the lumbar support. Push the switch
upward or downward to raise or lower the lum-
bar support.
Driver Memory Seat — If Equipped
This feature allows the driver to store up to two
different memory profiles for easy recall through
a memory switch. Each memory profile contains
desired position settings for the driver seat, side
mirrors, and power tilt and telescopic steering
column (if equipped) and a set of desired radio
station presets. Your key fob can also be pro-
grammed to recall the same positions when the
unlock button is pushed.
NOTE:
Your vehicle is equipped with two key fobs, one
key fob can be linked to memory position 1 and
the other key fob can be linked to memory
position 2.
The memory seat switch is located on the
driver’s door trim panel. The switch consists of
three buttons:
•
The set (S) button, which is used to activate
the memory save function.
•
The (1) and (2) buttons which are used to
recall either of two pre-programmed memory
profiles.
Programming The Memory Feature
NOTE:
To create a new memory profile, perform the
following:
1. Cycle the vehicle’s ignition to the ON/RUN
position (do not start the engine).
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, power tilt
and telescopic steering column [if equipped],
and radio station presets).
3. Push and release the set (S) button on the
memory switch.
4. Within five seconds, push and release either
of the memory buttons (1) or (2). The instru-
ment cluster display will display which
memory position has been set.
NOTE:
•
Memory profiles can be set without the ve-
hicle in PARK, but the vehicle must be in
PARK to recall a memory profile.
•
To set a memory profile to your key fob, refer
to “Linking And Unlinking The Remote Key-
less Entry Key Fob To Memory” in this
section.
Linking And Unlinking The Remote Keyless
Entry Key Fob To Memory
Your key fobs can be programmed to recall one
of two pre-programmed memory profiles by
pushing the unlock button on the key fob.
NOTE:
Before programming your key fobs you must
select the “Memory Linked To Fob” feature
through the Uconnect system screen. Refer to
“Uconnect Settings” in “Multimedia” for further
information.
Power Lumbar Switch
Memory Seat Switch
32