Chrysler 200 2017, Руководство пользователя, Страница: 19 / 557

after three minutes, turn all of the visual signals off after 15
minutes, and then the vehicle security alarm will rearm
itself.
To Arm The System
Follow these steps to arm the vehicle security alarm:
1. Make sure the vehicle ignition is cycled to the
⬙
OFF
⬙
position (refer to
⬙
Starting Procedures
⬙
in
⬙
Starting And
Operating
⬙
for further information).
2. Perform one of the following methods to lock the
vehicle:
•
Push the lock button on the interior power door lock
switch panel with the driver and/or passenger door
open.
•
Push the lock button on the exterior Passive Entry
Door Handle with a valid key fob available in the same
exterior zone (refer to
⬙
Keyless Enter-N-Go — Passive
Entry
⬙
in
⬙
Things To Know Before Starting Your Ve-
hicle
⬙
for further information).
•
Push the lock button on the key fob.
3. If any doors are open, close them.
To Disarm The System
The vehicle security alarm can be disarmed using any of
the following methods:
•
Push the unlock button on the key fob.
•
Grasp the Passive Entry Unlock Door Handle (if
equipped, refer to “Keyless Enter-N-Go — Passive En-
try” in
⬙
Things To Know Before Starting Your Vehicle
⬙
for further information).
•
Place the ignition system out of the OFF position.
NOTE:
•
The driver’s door key cylinder and the Trunk button on
the key fob cannot arm or disarm the vehicle security
alarm.
•
The vehicle security alarm remains armed during power
trunk entry. Pushing the trunk button will not disarm
the vehicle security alarm. If someone enters the vehicle
through the trunk and opens any door the alarm will
sound.
•
When the vehicle security alarm is armed, the interior
power door lock switches will not unlock the doors.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17