English
–
V.202106
USB Stand Alone interface
7
Datasheet / Technical manual
LED Display Menu Key
The LED Display shows the current scene, zone, page, colour, operating mode, speed, dimmer and firmware update mode.
The displayed values vary according to the selected mode.
PC
-
The interface is connected to a computer and communicating with the software. In this mode, the
interface is under software control.
SA
-
Scene trigger mode. In this mode, the LED display shows the current scene number (from 01 to
511). By default, when no scene is playing, all DMX channels are set to 0.
“
00
”
indicates Blackout
and the interface sends nulls (0x00) on all DMX channels.
PA
-
Page mode. There are 10 pages of 8 scene, it is about 80 scenes maximum to be triggered. The
display indicates the page number from P0 to P9. In this mode, use the 8 trigger buttons play the
scenes stored in the selected page.
Co
-
Colour mode. The display indicates the selected custom colour number (from C1 to C8). Or the
colour value applied from the colour wheel.
SP
-
Speed mode. Increase or decrease the current scene speed. The display indicates the speed of
the current scene from -9 to 9.
dI
-
Dimmer mode. Increase or decrease light output of scenes and custom colours. The display
indicates the general intensity from -9 to 9.
Pr
-
Programming memory Mode. Pr is displayed when the interface is writing a show to memory.
Zo
-
Zone mode. After programming the interface memory, Zone A is selected by default. In this mode,
the LED display shows the current Zone: Global, A, B, C, D, E.
Zone A to D display :
Global Zone display :
The display switches between the current zone and the running scene number every 3 seconds.
Use + or
–
to navigate between zones. Scene buttons may be pressed to instantly trigger scenes
without entering in the zone with the
button.
bL
-
Updating firmware mode. Displayed when a new firmware is being written to memory.
The display will flash during the firmware update. Do not disconnect the interface in this mode.
YE
-
Year setting in the clock setting mode.
Mo
-
Month setting in the clock setting mode.
dA
-
Day setting in the clock setting mode.
ho
-
Hour setting in the clock setting mode.
Mi
-
Minute setting in the clock setting mode.
CL
-
Confirmation of the new clock setting.
Clock and calendar Manual setting
It is possible to setup the internal interface clock and change or update its date and time manually.
To access the clock mode, hold the ”
+
”
and “
-
“ buttons for 5 seconds.
"YE" shows the current year setting.
Use the + and - buttons to select the correct year and confirm by pressing the
button.
Repeat this procedure to set month (Mo), day (dA), hour (ho) and minutes (Mi).
After confirming the minutes, “CL” will blink to confirm that the new configuration is saved to memory.
The interface clock is now calibrated to your new setting.
This function is useful for setting the interface clock directly on site and without the use of a computer.
