Christie MicroTiles, Инструкция по установке и настройке

Страница: 24 / 43

In an array, the physical size of the gap between two adjacent screens is affected by temperature and
humidity. Improper installation of the tiles also affects both the size and consistency of screen gaps.
With proper installation, the average physical screen gap is typically 1.3mm at 25°C (77°F) ambient
and 50% non condensing relative humidity, with a variance of ± 0.3mm. Feeler gauges should be used
to measure screen gaps accurately.
1. Ensure the surface of the screen removal tool is clean and free of debris to avoid damaging the
screen.
2. Before installing the screens, remove the lens guard from the tiles and the dust cap from the
lens.
Replace the lens guard and the dust cap anytime the array is disassembled and shipped.
3. Open the handle on the screen removal tool and gently place it in the center of the screen.
4. Carefully, push the screen removal tool towards the screen using moderate pressure (no more
than five lbs / 2.27 kg).
5. Close the handle on the screen removal tool to apply suction.
6. Carefully lift the screen from the work surface.
7. Pull the screen tether out from the top of the tile housing and hook it into the locking latch on
the screen.
The tether ensures the screen does not fall if subjected to excessive force or vibrations.
8. Ensure the screen tether is secured before completely installing the screen.
9. Line up the two mounting holes on the screen with the two pins on the tile and carefully press
onto the tile.
Magnets on the housing secure the screen to the tile.
Removing the screen from the tile
Take precautions when removing the screen from the tile.
Notice. If not avoided, the following could result in property damage.
• Excessive force or repeated screen removal may damage the screen.
Installation and Setup
Christie MicroTiles Installation and Setup Guide 24
020-100329-15 Rev. 1 (05-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.