FHD554-XZ-H and FHD554-XZ-HR LCD Panels User Guide
020-001725-01 Rev. 1 (11-2019)
Copyright © 2019 Christie Digital Systems USA, Inc. All rights reserved.
Installing a display panel
21
Inserting the power modules into the Remote Power Rack Shelf
The power modules, or rectifiers, convert an AC power source into the DC current required by the product.
1.
Remove the cover from the rectifier slot.
2.
Slide the power module into the front of the chassis until it clicks into place.
3.
To lock the power module, lift the handle and snap it into place.
4.
Repeat steps 1 to 3 for each rectifier in the Remote Power Rack Shelf.
Connecting the LCD display panel power cables to the Remote
Power Rack Shelf
To power the FHD554-XZ-HR panels, connect the cables between the LCD panels and the Remote Power Rack
Shelf.
1.
Connect the main power cable to the Remote Power Rack Shelf.
2.
Connect the LCD panel cable to the main power cable.
If the power cord supplied with your product is not long enough to connect the first display panel in an
array to the Remote Power Rack Shelf module, you must purchase a power cord of an adequate
length. Christie recommends one of the pre-terminated power cables offered as Christie accessories,
or that you create a custom cable using the Christie Main Power Cable Spool (P/N 154-122106-XX),
Connector Kit (P/N 154-125109-XX), and Molex Crimping Tool (P/N 154-124108-XX). For more
information on the Molex Crimping Tool, see the Molex documentation.
3.
To connect one display panel to another, connect the DC daisy-chain power cord to the Out port of a
panel, then connect the other end of the power cord to the In port of another panel, within specified
system limits.
4.
Plug the Remote Power Rack Shelf into the building outlets in the wall or the floor.
Logging in to the Remote Power Rack Shelf web interface
To make changes to the Remote Power Rack Shelf, use Internet Explorer.
1.
Connect a computer to the Remote Power Rack Shelf with a network crossover cable.
2.
To access the web interface, in the Control Panel, change the IP address and subnet mask of the
computer to be on the same subnet as the Remote Power Rack Shelf.
If the IP address and subnet mask on the Remote Power Rack Shelf have not been changed from the
Содержание FHD554-XZ-H
Страница 1: ...User Guide 020 001725 01 FHD554 XZ H and FHD554 XZ HR LCD Panels ...
Страница 58: ......
