FHD554-XZ-H and FHD554-XZ-HR LCD Panels User Guide
020-001725-01 Rev. 1 (11-2019)
Copyright © 2019 Christie Digital Systems USA, Inc. All rights reserved.
Installing a display panel
19
•
Ambient conditions might impede the operation of the remote control. If this occurs, point the remote
control directly at the display panel and repeat the desired operation.
Locking or unlocking the remote control
Lock or unlock the remote control buttons to prevent unauthorized individuals from changing the display
settings.
1.
On the remote control, press
ENTER
>
ENTER
>
EXIT
>
EXIT
>
ENTER
>
EXIT
to lock the remote
control.
2.
To unlock the remote control, enter the same sequence of commands.
Mounting a display panel
Use only the approved wall-mount kit designed for your display panel.
If you decide to wall-mount a display panel, ensure that the wall-mount bracket is installed according
to the instructions that are included with it. The wall must be capable of supporting three times the weight
of the display panel or be reinforced.
To ensure the mounting brackets clear any protrusions on the rear of the panel, Christie recommends using
spacers with a minimum height of 6.35 mm (.25 in).
Mounting brackets may block access to the connector ports. To ensure the preferred mount allows access
to the connectors, refer to the display panel line drawings on
for measurements.
At the location where the space between tiles is the tightest, use the spacer tool to ensure there is a
minimum of 0.5mm, or the thickness of a credit card, between adjacent LCD display panels.
Connecting signal to the display panel
You can connect a display panel to video sources, external controllers, and power sources. Follow these
guidelines when you connect equipment to a display panel.
•
Turn off all equipment before making any connections.
•
Use the correct signal cables for each source.
•
For best performance and to minimize cable clutter, use high-quality cables that are only as long as
necessary to connect two devices. For example, avoid using a 20-foot cable if a 6-foot cable is
sufficient.
•
Ensure that the cables are securely connected. Tighten all thumbscrews on connectors that have
them.
Caution!
If not avoided, the following could result in minor or moderate injury.
•
TIP HAZARD! Center align the product on the stand or mount.
Содержание FHD554-XZ-H
Страница 1: ...User Guide 020 001725 01 FHD554 XZ H and FHD554 XZ HR LCD Panels ...
Страница 58: ......
