Use of Entero Mounting Plate Instruction Sheet
1 of 4
020-100406-02 Rev. 1 (09-2010)
Use of Entero Mounting Plate
Instruction Sheet
INTRODUCTION
Use these instructions for the Entero mounting plate when installing an RPMWU/RPMSP-LED01
projector on a 6-axis adjuster (000-101642-01) in a CC50-2301/CC67-3001/CC72-3301 display cube
system. Or when using the mounting plate for direct thrown installations.
TOOLS REQUIRED
• Phillips Screw Driver
INSTRUCTIONS
Installation options for the Entero mounting plate are:
• Front access in a display cube
• Rear access in a display cube
• Direct throw in an alternative installation
FRONT (F) AND REAR (R) ACCESS FOR CUBE INSTALLATIONS
For Entero installations, the 6-axis adjuster comes with the Entero
mounting plate pre-installed for rear access. Rear and front access
refer to the orientation of the adjuster in the cube providing
access to the adjuster controls from the back of the cube or from
the front of the cube. The mounting plate is always installed on
the adjuster with the flange on the side opposite from the adjuster
controls (Figure 1).
Figure 1 Mounting Plate on
6-Axis Adjuster
