Christie Easy Petrol Post Driver CHPD78-1, Инструкции по безопасности, эксплуатации и обслуживанию

Страница: 13 / 32

7
Operating instructions
Pre-start checklist
Check point Remedy
Check engine oil
Honda GX35
• Fill to the top thread of the filler while the motor is in a vertical
position
•
! Overfilling will damage the engine
• Refer to Honda Owner’s Manual GX35
• Use 10W30 mineral engine oil
Check fuel level • Fill with regular unleaded fuel only
Visually inspect
striker and barrel • Look in the receiver guide of the Post Driver to check for damage
to the striker or tube, repair/replace if damaged
• Dislodge any debris (such as tar, timber picket splinters with a WD
spray into the receiver barrel
Visually inspect
all fasteners Tighten as necessary:
• Cover plate screws.
• Receiver guide screws.
• Screws in engine guard.
• Screws in body castings.
If screws repeatedly come loose;
- remove screw entirely,
- clean both thread and screw with degreaser/solvent
- apply Oil Tolerant Locking Compound & re-affix screw (such as
Bondloc B243).
Safe starting
• Start and operate the Christie Post Driver unit outdoors, and in a ventilated
area
• Never wrap the Honda GX35 pull starter rope around the hand
• Do not quick release the Honda GX35 starter grip, guide the starter rope back
slowly to permit the rope to rewind properly
• Failure to observe instructions regarding the pull starter may result in injury to
the operator’s hand and damage to the starter
i. Ensure the ground is firm or select a solid surface, in an open well-ventilated area.
ii. Maintain good balance and secure footing on both feet, with feet shoulders width
apart.
iii. Place the Post Driver, resting on the receiver barrel on firm ground with the top handle
in left hand to stabilize machine.
iv. Turn On/Off switch to On (I). Prime the fuel bulb, and engage the choke.
v. Grasp the pull cord toggle; pull up and out. Excessive force or speed is not required.
vi. Guide the starter rope back slowly to permit the rope to rewind properly.
vii. Once started, dis-engage the choke.
• Should the engine not start easily, or the pull starter offer resistance, refer to the
Troubleshooting section.