Christie DHD675-E, Руководство по обслуживанию

Страница: 17 / 122

Section 3: Service Setup
E Series 675/775 Service Manual 3-1
020-000546-04 Rev. 1 (04-2017)
3 Service Setup
This section describes special adjustments and related details that may require the attention of a Christie
accredited service technician, whether done periodically or after a specific module replacement.
3.1 Factory Mode and Service Mode
The DWU675-E/DHD675-E/DWU775-E/DHD775-E provides 2 menus that are restricted to personnel with
service level access:
3.1.1 Factory Mode
Perform the following actions to enter Factory Mode :
1. Turn on the projector.
2. Press
A
UTO
,
LEFT
,
LEFT
,
LEFT
keys sequentially on the Remote Keypad or the Built-in Keypad.
NOTE:
If signal is present at one of the inputs, it will be necessary to press the
M
ENU
key before using this
sequence.
Table 3.1 Factory Mode
FACTORY MODE DESCRIPTION
Model Name Show Model Name
Optional Displays which optional hardware is installed: Color Wheel and PW610/GEO
board
PW392 FW Ver Displays main scaler Firmware version
PIC FW Ver Displays PIC/Keypad version
PW808 FW Ver Displays LAN Firmware version
GEO-A FW Ver Displays Firmware version of chip A on GEO/Warping board
GEO-B FW Ver Displays Firmware version of chip B on GEO/Warping board
Waveform Ver. Show Waveform ID
Factory Reset Perform factory reset
ADC Calibration Perform calibration of ADC chip (Analog to Digital convertor)
Color Speed Press
S
ELECT
key to switch Color Wheel Speed to 2x or 3x
Color Wheel Index Color Wheel Index
Waveform ID Display Waveform ID version
Burn In Enter Burn In Mode Menu
DA Home Set DA (Dynamic Aperture) home position
DA Change DA position (open or close)
ABC DA Step Displays step position of Dynamic Aperture for Auto Brightness setting
ABC Feedback Shows feedback on Auto Brightness setting