Christie D4K40-RGB, Инструкция по установке и настройке

Страница: 22 / 54

Only use the holes located on the handles for installing the feet in portrait mode.
6. To assist with stability and prevent sway, Christie recommends installing two 2-inch ProBurger
clamps on each handle. Orient the clamps on either side of the projector's center of gravity.
Lifting and positioning the projector
Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
• A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
• Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
1. Position each person at the corners of the projector.
2. Lift up the projector and move it to the location where it will be used.
3. Position the projector so it is centered and parallel with the theater screen. If space is limited,
aim the projector slightly off-center and use lens offset to center the image on the screen.
Leveling the projector
Use the projector feet to level the projector.
1. To adjust the vertical position of the projector, extend or retract the adjustable feet on the
bottom of the projector using the adjustable knobs on the feet.
Installation and setup
4K40-RGB Installation and Setup Guide–D4K40-RGB, Roadie 4K40-RGB 22
020-102961-03 Rev. 1 (08-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.