I
Tool box and convergence access
J
Light engine air filter intake
Preparing the installation site
Make sure the installation area is ready for the components.
1. Clear the installation area.
2. Post laser hazard warning signs at all entry doors.
3. Place each component near its installation location.
Lifting and positioning the projector
Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
•
Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
This product must be installed in a landscape orientation, with all four feet supported on a level
surface. Do not install or operate the projector in an inverted position. If your site has any installation
requirements other than a typical theater projection booth, contact Christie for assistance.
Before lifting and positioning the projector, refer to the light intensity hazard distances.
1. Position each person at the corners of the projector.
2. Place both hands under the corner, grasping the projector frame.
Do not lift the projector using any feature on the projector cover, such as the cover louvers or
lens opening.
3. Lift up the projector and move it to the location where it will be used.
4. Position the projector so it is centered and parallel with the theater screen.
If space is limited, aim the projector slightly off-center and use lens offset to center the image
on the screen.
Connecting to power
The projector must be connected to power using a hard-wired connection.
The projector light source requires a permanent AC connection to operate. An uninterruptible power
supply (UPS) to provide backup power for the projector electronics only is also available. When
connecting the projector to AC power, follow all electrical codes for your location.
Installing and setting up
Cinema 2K-RGB Installation and Setup Guide–CP2415-RGB and CP2420-RGB
19
020-103259-01 Rev. 1 (10-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Содержание CP2415-RGB
Страница 1: ...Installation and Setup Guide 020 103259 01 Cinema 2K RGB CP2415 RGB and CP2420 RGB...
Страница 52: ......