Christie CineLife+ RGB PLF CP4450-RGB, Инструкция по установке и настройке

Страница: 32 / 61

Connecting the chiller power cable
The chiller is connected to AC power through a power supply terminal located at the front of the chiller
unit.
The wires of the supplied power cord are connected to the three terminals in the power supply
terminal.
• A qualified electrician is required to connect the chiller unit to AC power. For detailed
information, refer to the documentation provided by the chiller manufacturer.
• For electrical rating information, refer to the license label on the chiller. Additional information is
available in the chiller's product documentation.
1. Remove the cover for the power supply terminal by unscrewing the two cover screws.
2. Ensure the rubber grommet is installed on the cable at the connector end. The grommet
provides strain relief protection for the power cable.
Installing and setting up
C RGB PLF Installation and Setup Guide–CP4450-RGB 32
020-103072-02 Rev. 1 (09-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.