Christie CineLife+ RGB PLF CP4450-RGB, Инструкция по установке и настройке

Страница: 29 / 61

4. Tighten the mounting arm until it fits tightly on the ball joint.
5. Connect the touch panel USB cable to the USB port on the rear of the touch panel.
6. Connect the other end of the USB cable to a USB port on the projector input panel.
7. To install the TPC on either side of the projector, uninstall the the four screws securing the ball
mount and remove it.
Leave the small adapter puck with the four screws installed.
8. Select a side to install the ball mount with the three button head screws.
The ball mount has hole patterns for 4-point and 3-point mounting.
9. Install the TPC to the new ball location.
10. To turn the touch panel on, press the power button on the top of the panel.
If the projector is not connected to AC power with breakers in the ON position, you cannot turn
the touch panel on.
To ensure that the touch panel starts up successfully, the touch panel must be connected to the
projector before the projector is powered on.
Projector power modes
The C RGB PLF projectors track laser operation hours for the laser optical sub-systems (LOS).
The projector operates with the following power modes:
Installing and setting up
C RGB PLF Installation and Setup Guide–CP4450-RGB 29
020-103072-02 Rev. 1 (09-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.