Christie CC50-2301, Руководство по установке

Страница: 19 / 56

Section 2: Installation and Setup
CC50-2301/CC67-3001/CC72-3301 Installation Manual 2-9
020-100248-03 Rev. 1
Figure 2-8 Cube Enclosure Mounting Locations
Installation Tips
• Insert the long screen-holding bolts into the back of the cubes before the cubes are installed onto the
structure. It will be difficult to install them later, if the system is installed close to a back wall.
• Install cube enclosures starting from the center and work outwards.
• Always ensure that the edges of the display cubes are flush before adding another row. Proper alignment
reduces issues with image geometry once the screens are installed and ensures that the wall has a
“seamless” appearance. It is difficult and time consuming to fix an alignment problem near the bottom of a
wall.
Adding the First Row of Display Cube Enclosures
Stacked display cubes can tip over and cause injury or damage when not properly
secured. The display wall must be supported during and after installation to a structurally sound surface
such as a permanent wall or an installer-approved free-standing external support structure.
Lift equipment MUST be used to lift display cubes into position on higher rows. A crew
of two or more can lift a display cube into position on the first row.
See Figure 2-9 .
1. Place the mirror in a “neutral” position, where the adjusting screws do not apply any pressure, in either
direction, on the mirror.
2. Install the first row of display cube enclosures onto the pedestals, beginning with the centre and working
outward, by completing the these steps for each enclosure in the first row:
a. Approaching the pedestal from the back, use proper lifting methods to lift the cube enclosure over the
pedestal and lower it in place.
b. With the display cube enclosure resting on the pedestal, adjust its alignment so that the side and rear
edges between the two components are flush and the mounting holes are aligned.
c. Using 6 M6 x 75mm screws (4 for CC50) with washers and hex nuts, secure the cube to the pedestal
below. Hand-tighten the hardware to allow small adjustments while other display cubes are added to
C
B
B
B
A
A
A
C
A
A
Use to fasten side-by-side display
cubes together, (4) on each side
panel
B
Use to fasten the display cube to the
pedestal or to the cube below it,
(2) at the back and (2) at the front
C
For CC67/CC72 display cubes only,
use to fasten the display cube to the
pedestal or cube below it, (2) on the
support bracket.