Christie 130-002103-01, Руководство пользователя

Страница: 61 / 144

ArrayLOC
Matrix StIM™ WQ/SIM WQ User Manual 49
020-100883-01 Rev. 2 (06-2013)
ArrayLOC
Matrix StIM™ WQ projectors use ArrayLOC to display a common gamut and brightness across an
array of projectors. ArrayLOC monitors the projector array and adjusts settings automatically. The
following section outlines how to manage color using ArrayLOC.
Take Control of the Array
Use this menu to set up array color and brightness. By default ArrayLOC is configured to display the
EBU gamut at the maximum brightness the array can support.
1. On the projector you want to work with,
access the ArrayLOC menu: Main Menu >
ArrayLOC.
2. Check Synchronize to This Projector to
make the current projector the master.
Changes you make in the Array Color
Target, Bright/ColorLOC Configuration,
and RGB and IR Brightness Targets on the
master projector are broadcast to the other
projectors in the array. The master projector
has access to most settings under the Bright/
ColorLOC Configuration and Array Color Target
submenus. These settings are greyed out on
the other projectors in the array to prevent
conflicting information from being sent.
3. Enable Bright/ColorLOC Mode to automatically achieve and maintain a target gamut and
brightness. See Configure Bright/ColorLOC on page 51.
i
ArrayLOC is enabled by default.
i
While working in the ArrayLOC menu and submenus, ArrayLOC displays a warning if
adjusted settings fall outside the range the system can adjust for.
Warnings include:
• Minimum brightness not met (BCLOC disabled)
• Minimum brightness not met (Warning)
• Min Gamut not met (BCLOC disabled)
• Min Gamut not met (Warning)