Freeze-dryer Alpha 3-4 LSCbasic
6 Operation
Version 11/2018, Rev. 1.9 of 01/12/2021
• sb
59 / 117
Translation of the original operating manuel
The user interface is divided into three main windows that can be called up
by touching the corresponding buttons:
Process
This window is also the standard user interface. It is used to control the
freeze-drying process manually.
Options
This window is used for personalised settings that enable the users to
adapt the system as far as possible to their respective area of activity.
?
In this window, the users can find all of the relevant information concerning
the control system at a glance. In the event of enquiries at the factory,
these data facilitate the assignment and expediting of the processing of the
enquiries.
Pos : 152 /010 Univ ers almodul e/ Leerz eile @ 0\mod_1202116244500_0.docx @ 114 @ @ 1
Pos : 153 /010 Univ ers almodul e/ Leerz eile @ 0\mod_1202116244500_0.docx @ 114 @ @ 1
Pos : 154 /200 Chris t/361 GT-BA Labor-Pil ot ( PROJ EKTE)/ Alpha/Al pha 1- 4_2-4_3-4 St andard/ Alpha 3-4 LSCbasic/ 060 Betrieb/ 060- 0050-0010-0010 H aupt fenst er Proz ess - nur Alpha 3- 4 @ 84\mod_1627895638212_68. doc x @ 884138 @ 4 @ 1
6.4.1.1
Main window "Process"
This main window shows all of the relevant process data. Here, the
individual phases of a freeze-drying process can be controlled manually.
1
Status line
2
Schematic system
diagram
3
Value windows
4
Button "Tools"
5
Button "Set" (set
values)
6
Button "Process and
equipment messages"
7
Button "Operating
mode: select/start"
8
Button "Stopp"
Fig. 25: Overview of the main window "Process"
