CHIWAI Quan Wei, Инструкция по использованию и обслуживанию, Страница: 24 / 90

20
3) If there is any malfunction, it should be repair first for future use.
4) The condensate water of oil and gas barrel, oil cooler and rear cooler is discharged after a few
days.
4.4.2 Shut down for more than two months
1) In addition to the above procedures, the following additional procedures are required:
2) Close all openings to prevent moisture and dust from entering.
3) Wrap oil paper or similar paper, such as safety valve, starter disk, etc., to prevent corrosion.
4) Replace the lubricating oil and run for 30 minutes before stopping the operation. After two or
three days, remove the condensate from the oil barrel and the oil cooler.
5) Completely drain the cooling water.
6) Remove the machine to less dust and store in a dry place as much as possible.
4.4.3 Reboot procedure
1) Remove plastic paper or oil paper from the machine.
2)
Measuring the insulation of the motor should be above 1m Ω .
3) Other procedures such as those described in the test run.
5.0 Intelligent controller
5.1 MAM6080 Touch screen debugging instructions
5.1.1 Key instruction