FS-8705-12 Federal Signal Ultravoice - Electronic Siren Controllers Driver Manual
Page 25 of 30
© 2021 CHIPKIN AUTOMATION SYSTEMS
Appendix B.
Troubleshooting-Tips
This section is blank.
ERROR MESSAGE
EXPLANATION AND CORRECTIVE ACTION
We have shown place holders for the
parts of the message which change.
%s is a place holder for a text string.
%d is a place holder for a number
%c is a place holder for an alpha
character.
FSU_ESC:#1 Err FSU_ESC_Function='%s' is
unknown
The driver has been configured incorrectly.
The Map Descriptor parameter
FSU_ESC_Function_Name
must be specified
correctly. Review Chapter 4 and the examples.
Correct the configuration and then download the
corrected configuration file and reset the
FieldServer for the changes to take effect.
FSU_ESC:#2 Err. The Function Name must
be specified.
See Error #1
FSU_ESC:#3 Err. Zone command out of
range. %s[%d]Value=%d
Where %s[%d] specifies a Data Array and
offset.
Valid Entries in the Data Array are 1-4 for zones A-
D
The most likely cause for this message is either the
driver has started up and there are zero’s in the
Data Arrays or the other protocol has written a
number to the FieldServer that is out of the valid
range.
