www.chinowing.com
29
The figure above shows the
channel monitoring interface
, showing the status of
each channel of the remote control. When the remote control is in the wrong
position or there is a rudder phenomenon, click the red box position in the upper
left corner three times to bring up the option of remote control calibration
function, and calibrate each analog channel.
Click <
Joystick Calibration
> to start calibration; toggle all the joysticks and knobs,
including T1, T2, T3, T4, T5, T6, T7. T8 to ensure that all analog channels touch
the maximum value, the minimum value of stroke and then finally to the middle
position. Click to complete the calibration. After the calibration is completed,
toggle each joystick to see if the parameters setting software display matches the
action to verify that the calibration was successful.
The channel display of the remote control is divided into three parts. The left part
shows the output value of SBUS-1, the middle part shows the corresponding status of
each channel, and the right part shows the output value of SBUS-2. SBUS1 and
SBUS2 can be configured separately.
8.3 Channel Configuration
1. Click the channel configuration button, the above figure shows the
configuration interface, you can configure SBUS1 and SBUS2 respectively.
Each S-BUS channel CH01-CH16, can freely correspond to T1 , T2 , T3 , T4 , T5, T6,
T7, T8, F1, F2, F3, F4, F5, F6, F7, F8, F9, F10, F11, F12.
T1 , F1, F2, F3, F4 are main joysticks. T5, T6, T7, T8 is auxiliary joysticks. F1, F2,
F3, F4, F5, F6, F7, F8, F9, F10, F11, F12 are buttons.
2. CKey1 - CKey5 are virtual key combinations, SCKey1 and SCKey2 are virtual
super key combinations; mapping a virtual channel requires setting the channel
