Chino LE5100, Инструкция по эксплуатации

Страница: 80 / 90

13-8
13-3-2. Partial compression and expansion recording
・ This setting can be done every channel.
・
Since maximum 2 dots can be set, maximum 3 compression or expansion ranges are obtained.
・
Set the dot recording position by % and then, set an analog recording scale value at the dot (%).
【
Setting method
】
*
Set the following setting after checking if the [COMP.] is selected on analog recording format (p13-6).
（ Note1 ）
Set the recording position (%) to 0%
－
100% in the
0mm － 250mm chart. Set the recording range by a
scale value at the set recording position.
Be careful with the decimal point position.
① Select OPT. MENU to enter the setting display mode, referring to page
6. A window opens and a setting items table is displayed.
② Select a desired item to be set by moving the cursor by means of  ・
 ・▲・▼
keys.
③ Select COMP.
④
Press Enter key to enter the setting table display (12 points collective)
screen.
(For the setting table display (12 points collective) screen, refer to
⑥
)
⑤ For stopping the setting, press Esc key. The screen returns to the last
one, each time Esc key is pressed once.
⑥ Move the cursor to a desired channel number to be set by ▲ or ▼
key.
The cursor does not move to any item other than CH. No.
⑦
After selecting a channel to be set, press Enter key.
A window opens and a setting parameter entry screen is displayed.
(For the setting parameter entry screen, refer to
⑧
)
⑧ Move the cursor to a desired channel number to be set by  ・  ・▲・
▼
keys.
Each time Enter key is pressed once, the cursor move in the sequence
of Spread Recording
→
S1 Pos.(%)
→
S1 Span
→
S2 Pos.(%)
→
S2 Span
→
S3 Pos.(%)
→
S3 Span
→
S4 Pos.(%)
→
S4 Span
→
Set. The Spread Recording parameter input area is determined by
selecting a setting parameter. A window opens. Select a parameter
by
▲
or
▼
key.
After setting this screen, bring the cursor to Set .
⑨
Terminate the setting (change, addition) by pressing Enter key.
⑩
For copying a set value, press [Func 2] key in the screen in
⑥
.
Input the copy source and copy destination by numeric keys.
After the end of setting, bring the cursor to Copy and press [Enter]
key.
Setting table display(12 points collective)
Status in
④
on page 6
Set?
①
Esc key
ＮＯ
⑤
End
ＹＥＳ
Select a channel by
using
▲
or
▼
key
⑥
Selection of setting items
 ・  ・▲・▼
keys
②
Enter key
③
Enter key
⑦
COMP.
④
Setting parameter display
Set?
ＮＯ
ＹＥＳ
Set by using
 ・ 
・
▲・▼
keys and numeric
keys (Change, addition)
Enter key
Is setting
continued?
ＹＥＳ
⑧
Status in
④
on page 6
ＮＯ
Esc key
⑨