China Electronics Technology Instruments AV3672 Series, Руководство пользователя

Страница: 95 / 424

4 Measurement Setting
4.3 Setting of Frequency Range
91
Menu path: [Trace] > [New Trace]
. Click “
Receivers
” in the dialog box.
2) [New Trace] dialog box (any ratio and non-ratio power measurement)
a) [Active] check box
Tick it to create a new trace.
b) [Numerator] zone
Select the numerator of any ratio measurement or the receiver for non-ratio power measurement.
c) [Denominator] zone
Select the denominator of any ratio measurement. The value is 1 in non-ratio power measurement.
d) [Source] box
Select the source signal output port of the analyzer.
e) [Channel Number] box
Select the channel for the new trace.
f) [Create in new window] check box
If this check box is selected, a trace will be created in the new window. If this check box is cleared, a trace will be
created in the current active window.
g) [Auto-Create Window] check box
If this check box is ticked and the number of traces in the window exceeds 8, excessive traces will be automatically
created in a new window.
If this check box is cleared and the number of traces in the window exceeds 8, excessive traces will not be created.
4.2.4 Measurement mode of trace change
The trace must be activated before setting and modification.
1) Change the trace state
Click the [Track state] button in the window. The corresponding trace will be activated.
Fig. 4.6 Change of Track Activation State
2) Change the measurement parameter of active trace
Menu path: [Response] > [Measure] . The measure sub-menu will appear. Or, right-click the trace title bar, and
click [Measure] in the menu, as shown in Fig. 4.7.
Fig. 4.7 Setting of Parameter S Measurement Mode of Activated Trace
4.3 Setting of Frequency Range