Chilipepper CP-2011 Скачать руководство пользователя страница 1

Chilipepper CP2011

 

Installation Instructions 

 

WARNING:  Risk of electric shock.  This pump is supplied with a 

grounding conductor and a grounding-type attachment plug. To 

reduce the risk of electric shock, be certain that it is connected 

only to a properly grounded grounding-type receptacle. 

Package Contents.

 

The Chilipepper Appliance 

Hex Adjusting Tool 

Temperature Adjusting Screw Driver 

One push button with cable 

Two brass “T” fittings 

ANY OF THESE ITEMS CAN VOID THE WARRANTY 

* Flexible hosing MUST be used.  The Chilipepper was NOT  

  designed for rigid pipe connections.  

 

* Be careful connecting or disconnecting the hoses to the 

Chilipepper, too much torque could damage or break the pump 

head.

 

* DO NOT USE pipe dope on the connections to the Chilipepper, 

  (Teflon tape is OK)     Pipe Dope could get into the pump 

impeller and slow it down or burn up the pump.

 

* The Chilipepper IS NOT waterproof.

  

Dry off the unit as soon as 

possible if it gets wet. 

 

 

INSTALLING THE CHILIPEPPER 

1.

 Turn off the Hot and Cold water shut-off valves under the sink that 

supply water to the sink fixture.  (Fig 1) 

2.

 Open the faucet to relieve any system pressure. 

3.

 Disconnect the existing hoses from both shut-off valves. 

4

. Connect the brass T’s to the shut-off valves.  (Fig 2) 

( Most homes have 3/8 in. compression fittings on the shut-off 

valves 

but if the thread size is different a brass adaptor will be needed.)

5.

  Inspect the rubber washers in the hoses to make sure they can be 

reused and then connect the two existing hoses to the brass T’s.  

(Fig 3) 

6.

  Connect two new hoses to the Chilipepper, placing the unit 

on the floor of the cabinet. (Fig 4) 

  

  

 

  

Содержание CP-2011

Страница 1: ...pipe dope on the connections to the Chilipepper Teflon tape is OK Pipe Dope could get into the pump impeller and slow it down or burn up the pump The Chilipepper IS NOT waterproof Dry off the unit as soon as possible if it gets wet INSTALLING THE CHILIPEPPER 1 Turn off the Hot and Cold water shut off valves under the sink that supply water to the sink fixture Fig 1 2 Open the faucet to relieve any...

Страница 2: ...after the installation If there s a leak it will be easy to find 9 To install the push button drill a 5 8 hole in the cabinet where you want the button located Feed the cable through the hole in the cabinet the small hole in the container lid and connect the two cables to the push connectors on the Chilipepper Fig 5 Fig 8 Push the button into the cabinet hole If additional buttons are used wire th...

Страница 3: ...le Shooting Note There is some leakage possible through the Chilipepper pump from hot to cold When working on the plumbing in a home where the Chilipepper is installed it may be necessary to shut the hot or cold valve off at the fixture where the Chilipepper is installed to isolate the hot and cold water lines during plumbing repairs Press the start button and nothing happens 1 Be sure there is el...

Страница 4: ...with one rotation This will put more pressure on the spring and requiring more water pressure to open the check valve To Correct 3 the check valve needs to be cleaned How to clean the spring loaded check valve First the Temperature sensor has to be disconnected at the bottom of the Chilipepper This is done by pulling on the white connector and wiggling it side to side at the same time DO NOT PULL ...

Отзывы: