Chiko CBA-080AT3-HI-UL1, Инструкция по эксплуатации

Страница: 58 / 68

Chapter 5 Maintenance
and Checkup
56
5.6
Troubleshooting
No. Trouble phenomenon Cause Remedy
①
Organic EL display
shows nothing.
Power not turned on. Turn on the power.
Blown fuse Call for repair.
②
Motor fails to start or
suddenly stops
running.
Faulty motor
Call for repair.
The motor must be replaced.
Stopped due to
overload or abnormal
temperature
[1] Check that the exhaust/suction ports
are not blocked.
[2] Check the rated voltage.
[3] Check for multiple (octopus)
connections.
[4] Check for motor overheat due to either
filter clogging or suction temperature.
After the checks [1] to [4], take corrective
action, and then turn the main power
switch off and back on.
If the operation cannot resume, the
temperature thermostat of the motor may
be active. Turn off the main power, and
after 30 minutes, resume the operation.
Primary or secondary
filter not in place Install the primary and secondary filters
correctly.
Snap locks
disengaged
Engage all the snap locks firmly.
③
Lower suction force
Clogged filter
Replace filters.
“5.1 Replacing Filters” (page 50)
If filters are left clogged, the device may
result in “untrapped particles” or
“temperature rise in dust collector”.
Clogged piping or
suction port Check if piping is clogged or the suction
port blocked.
Faulty motor
Call for repair.
The motor must be replaced.
④ Untrapped particles
Improper filter
installation Reinstall filters.
“5.1 Replacing Filters” (page 50)
Filter broken or past
service life Replace filters.
“5.1 Replacing Filters” (page 50)
Clogged filter
Replace filters.
“5.1 Replacing Filters” (page 50)
⑤
Odd noise or vibration
from motor
Foreign matter
entered in blower.
Call for repair.
Broken motor bearing Call for repair.
※
For other phenomena, contact CHIKO AIRTEC.