CHIEF CEL024854, Руководство пользователя

Страница: 37 / 92

37
MI300T 220V
q j
Quantity and quality of the coolant
The coolant level is important for the correct operation of the machine. It must always be between the minimum and maximum level indicated on the
trolley. Top up with demineralized water if necessary.
Replace the coolant every 2 years :
1 Switch off the power supply using the switch located at the rear of the machine (OFF position) and disconnect the unit from the mains.
2 Place a bucket (min. 30 l capacity) under the machine drain hole.
3
Unscrew the drain plug located under the
machine using a 10 mm torx spanner.
(Ref. S6262)
4 Rinse the inside of the tank with running water to remove deposits.
5 Replace the drain plug. (
:
4 N.m)
6 Fill the tank with coolant (5l : 062511 / 10l : 052246)
7 Turn the power back on (ON position) and check for leaks.
TROUBLESHOOTING
TROUBLESHOOTING CAUSES SOLUTIONS
Clamp welding
The spot made does not hold or does not
enough
The caps are worn out. Change the caps.
The sheets are not clean enough. Check the preparation work.
The arm selected does not match the one
mounted.
Check the arm selected in the software.
The machine makes a hole in the sheet.
The caps are worn out. Change the caps.
Insufficient air pressure. Check the air pressure (min. 8 bar)
The surface is not properly prepared. Prepare/clean the surface to be worked on
Lack of power
Power supply problem. Check the stability of the mains voltage
Caps blackened or damaged. Change the caps.
Incorrect arm locking.
Refer to the chapter "Assembly and changing
the arms".
- Fast overheating of the machine.
- Power cable inflation.
No or poor circulation of the coolant.
Open the cart tank cap and observe the
movement of the coolant and correcrt return.
- Pump stopping
- Polluted coolant
- Circuit blocked.
Obstruction in the cooling circuit (pinched
pipe)
Check the sheathing between the trolley.
Check that the pump is working properly.
Check the condition of the coolant.
Gun
Abnormal heating of the gun
Incorrect tightening of the chuck.
Check the tightness of the chuck, the star
holder chuck, and the condition of the
sheathing.
Gun sheathing loose.
Replace the sheathing in order for the air
cooling to reach the inside of the gun
Incorrect positioning of the earth pad.
Check that the ground pad is in contact with
the right sheet metal.
Lack of power in the gun
Poor contact of the earth pad. Check the earth contact
Incorrect tightening of the chuck or acces-
sories.
Check the tightness of the chuck and acces-
sories, and the condition of the sheathing
Damaged consumables. Replace the consumables
EN