Page 11
SKU 97200
For technical questions, please call 1-800-444-3353.
Saw
5mm Hex
wrench (44)
3mm Hex
wrench (45)
Blade
guard (37)
Hole
Cover (39)
Bolt
(42)
nut
(38)
Blade
(46)
roller (3) secured in
place with roller pin (2)
Use both the mm and 3mm Hex Wrench to remove the Roller Pin (2) and Roller
(3).
Place the Blade on the Worm Wheel Shaft (1). Match the direction of the
rotation arrow on the Blade with the direction of the rotation arrows on the
housing.
Secure the Blade with the Roller and Roller Pin.
Replace Blade Guard and secure with the Nut and Bolt.
warning
always replace the Blade guard on the Saw before starting
work. it is dangerous to use this product without the Blade guard securely
attached.
Setting the Cutting depth
When setting the cutting depth, the thickness of the material being cut should be
taken into consideration. For best results:
when cutting wood, set the depth of the cut to be slightly greater than the
thickness of the material.
when cutting plastic, set the depth of the cut to be slightly greater than the
thickness of the material. If melting occurs, a greater depth setting should
improve results.
when cutting metal, the depth of the cut should be set about 1mm greater
than the thickness of the material. Do not cut steel or galvanized steel. When
cutting sheet metal, allow the machine to rest three minutes for every two
minutes of work.
this Saw is not recommended for cutting plasterboard because the dust may
cause the Blade Guard to stick.
4.
.
.
7.
1.
•
•
•
•
